View Single Post
  #307   Report Post  
Old December 3rd 03, 10:56 AM
N2EY
 
Posts: n/a
Default

In article , Mike Coslo writes:

But even if that is the case, it would seem to me to make more sense to
us a limit that is easily handled by virtue of equipment that will
handle the limit already on the market.


Exisitng equipment could still be used by LP licensees - they just have to turn
it down by 3 dB.

Would the manufacturers make equipment that only put out 50 watts?
Possibly, but what will be the resale value of the equipment? So the new
Class A ham has to go out and buy a new rig to make use of his or her
new priveliges? Remember not everyone wants to run a lot of power. 100
watts is something most people are comfortable with.


When the Novice was created back in 1951, the power limit was 75 watts input.
Which works out to about 50 watts output.

In a short time there were many manufacturers making transmitters for the
Novice market. Their resale value was good because there were always new
Novices coming along looking for a bargain.

And those manufacturers had to compete with homebrew and surplus rigs which
were in abundance back then. (One of the reasons Novices were limited to 75 w
xtal control was so that homebrew rigs used by Novices would be kept simple).

In fact many Novices used less than the full power allowed.

Let's see...there was the Ameco AC-1, the Heath AT-1, DX-20, DX-35, DX-40, d
DX-60 and HW-16, the Johnson Adventurer, Challenger, Navigator and Ranger, the
Drake 2-NT, the Hallicrafters HT-40.......to name just a few.

And this was when the amateur radio market was a lot smaller than it is today.


And the rationale for the reduction of power needs to be proven to me
anyway. How many Technicians have been hurt by using more than 50 watts
power?

Under Hans' plan, no existing hams would lose any privileges. So they don't
have to worry.

And do you think that the prospective ham should not know about RF
safety until they reach the equivalent of an Extra? This plan seems to
advocate that.


Until a few years ago there were no questions about RF exposure at all in the
pools.

One question is being overlooked, though: Why are most manufactured rigs rated
100 watts? Why not 50 watts, or 250 watts, or something else? (A very few are
rated at other power levels). Why 100.

The answer is about 50 years old.

73 de Jim, N2EY