Scott Schrader wrote in news:3F4E39DD.A59629F7
@visi.com:

try alcohol first for solvent, it should not mangle coil forms. if that
doesn't work, a paintbrush with a little bit of acetone is the next step
for solvent.


What I did for those stubborn slugs was to heat them with the tip of my
weller. The heat will soften the paint/sealant and not damage the coil
form.

r

Irv Finkleman wrote:

K5DH wrote:

I am restoring an old Kris 23+ tube-type CB radio.
As with most Japanese-made CB gear from that era,
the coil slugs are held in place with some sort of
glossy white paint-like sealer. How do I dissolve
that sealer without damaging the coil forms? I'm
unable to budge the slugs with a diddle stick, and
I don't want to risk fracturing a slug by trying
to force them.

73,
Dean K5DH

Usually a drop of solvent will loosen them. If the coil
forms are plastic it might be a problem, but you can test the
solvent on the end of the form first.
--
--------------------------------------
Diagnosed Type II Diabetes March 5 2001
Beating it with diet and exercise!
297/215/210 (to be revised lower)
58"/43"(!)/44" (already lower too!)
--------------------------------------
Visit my HomePage at http://members.shaw.ca/finkirv/
Visit my very special website at http://members.shaw.ca/finkirv4/
Visit my CFSRS/CFIOG ONLINE OLDTIMERS website at
http://members.shaw.ca/finkirv5/
--------------------
Irv Finkleman,
Grampa/Ex-Navy/Old Fart/Ham Radio VE6BP
Calgary, Alberta, Canada

-- If it's a "new economy," why do they want my obsolete old money?



--
"Any sufficiently advanced technology is indistinguishable from
magic."

Arthur C. Clarke (1917 - ), "Technology and the Future"