Tim Shoppa wrote:

Are "overtone" crystals cut differently than "fundamental" crystals?
Or are they just specified differently?

In particular, say I took a garden-variety 20MHz fundamental
microprocessor crystal and instead used it at its fifth overtone,
trying to hit 100 MHz. The LC network is there to make sure that it's
on its fifth overtone. Will this "misuse" mean that the oscillator
will be harder to start up, less stable, more noisy, ???, than a
crystal oscillator made out of a real overtone crystal? I don't mind
if I "miss" 100 MHz by a several tens or hundreds of ppm, as long as
it's stable there.

If anyone knows of a place that ships off-the-shelf 100 MHz fifth or
seventh overtone crystals, I can avoid this whole exercise.... :-)

Tim.

Overtone crystal cuts are not fundamentally different from fundamental
crystal cuts, so to a 1st-order approximation they'll work. Crystals do
have spurious responses that can cause mode jumping, and these responses
don't necessarily map the same way the overtones do, so using a 20MHz
crystal at 100MHz may or may not work, depending on the luck of the
draw. Other than that I don't know of any differences.

IIRC Digi-Key has 100MHz crystals, but I may be remembering 100MHz
oscillators. YMMV. IDNKWTFIAS. Caviat Emptor (so _that's_ what CE
means! Here I thought it was a quality mark). Etc.

--

Tim Wescott
Wescott Design Services
http://www.wescottdesign.com