Bill Grimwood wrote:
I have a heathkit SB 102 that I need the two rubber belts that run on
the
drive preselecator shaft. Where can I get these and how do you get
the
shaft out to slip them over the drive pullys?

Hi Bill, The belts are essentially "O" rings, and I would look for
auto parts, farm supply, or hardware stores that have a large selection
of O rings. As I remenber, you have to take the front panel off to get
the shaft loose to slip on new belts :-(
One other suggestion, Small Parts Inc. has a product called polycord
belting, where you make your own belt. The smallest diameter they have
is 1/8", may be too big. If you could use this stuff, you would not
have disassemble anything. Small Parts also has "O" rings.

73 Gary N4AST