Ahoy.

I have a new CB and a new Wilson Lil Wil antenna. The instructions with
the Lil Wil say to:

Check SWR on channel 1
Check SWR on channel 40
If channel 1 has a lower SWR than channel 40, cut 1/4" from the antenna
top and measure again...continue until the SWR for channel 1 and 40 is
about equal.

Channel 1 gave me a nice low 1:1.4
Channel 40 gave me a nasty 1:2.8

So I snipped off 1/4" and measured again.

Channel 1 gave me 1:1.3
Channel 40 gave me 1:2.5

So my question is, snipping off that 1/4" really improved the channel 1
SWR but only dropped channel 40 a little bit. How many 1/4" increments
am I gonna hafta snip before these two equal out?

Also, I'm guessing that at some point, channel 1 is going to start to go
back up (instead of improving)...should I stop there and live with
whatever the higher channels are displaying? Rather than continuing to
snip until 1 and 40 are about equal?

Thanks,

Kahuna