Reg:

Would you be so kinda as to allow me to, with my humble efforts, to write a
procedure in turbo pascal which I am thinking of... which will open a .txt
file, write variables to it (you may fill in your varibles as you please--I
need NOT be even aware of them to do this--will just supply generic variable
names such as "x", "y", "z"--which you replace with the real variable
names--and compile as you do), save and close this file--leaving a very
small text file which can be exchanged and discussed as necessary (even
posted here)?... and email the procedure in SOURCE CODE to you, you can
review it and act upon it as you please?

If so, give me a bit of time... I must remove a few other things off my
desk first... and load up turbo pascal...

Also, I will supply you with another email address immediately... I find
your exchanges too valuable... if you have patience, we will work something
out here... sorry about the returned mail... I am at a loss to the reason
at this time... will start looking here... thank you for pointing this out
to me...

Warmest regards,
John
--
Marbles can be used in models with excellent results! However, if forced
to keep using all of mine up... I may end up at a disadvantage... I seem
to have misplaced some already!!!


"Reg Edwards" wrote in message
...
| John,
|
| You sent me an e-mail. I replied. The reply was returned undelivered
| to me with a message about authentication which I don't understand. So
| let's try this route.
|
| It is possible to dump the program results screen to printer by using
| the "PAINT" program which comes with Windows. But that's ALL I know.
| Can you figure a way of doing a screen dump to printer? I've tried but
| failed.
|
| Interference with a program's source code is strictly barred.
|
| What is your particular interest in Vertune? Send me an e-mail and I
| will try once again to reply in like manner. If it doesn't work I
| will return to here.
| ----
| Reg, G4FGQ
|
|