Hi John:
terminations are an integral part of a filter design. there are a few
usual or widespread impedances in use. actually the impedance has a
marked effect on the filter's bandwidth, more than on shape. the
narrower the filter, the lower the impedance.
much more critical is the screening problem: the filters's cases must
be very well grounded! any leakage here goes around the filter.it's not
enough to solder to ground the relevant lead: you have to add a strap
from the case to ground.
Saandy 4Z5KS


John Wilkinson wrote:
Hi,
I am using a couple of 45MHz crystal filters in my first IF amp.
Has anyone any experience of using these, and give me any advice on
problems they encountered.
I think I have a problem with screening, as they require 700 Ohms
termination resisistance.

When the manufacturers spec a termination resistance, do the filters
themselves look like say 700 Ohms, or do I need to set this externally with
a resistance?

Best regards,
John.