"Richard Clark" wrote in message
...
On Sun, 14 Jan 2007 10:40:25 -0600, "William Becks"
wrote:

Any recommendations would be appreciated including any suggestions on
where
to send such an instrument repair and calibration service.

Hi William,

You already defined the cu Use it more.

For calibration, there is not much that can be done except to compare
to standards (you won't have them). This would have to be done at a
primary or secondary Metrology lab, an instrument repair shop might
claim the capability, but without certificates of traceability you
would be paying for a job they didn't do.

73's
Richard Clark, KB7QHC

Ive found that a tiny drop of DeOxit at the spring where the shaft contacts
the frame on most capacitors does wonders. Dont get carried away with it all
you need is just a little bit and dont get it on the plates.