No.. Sorry I didn't read your question correctly.. I'm not using coax
as a power cable, I'm using it as a antenna cable. The power lead is
the one that came with the HTX-212.. red and black. I assume since it
came with the unit it should be ok.




Nitespark wrote in message news:isQlc.38442$NZ4.17231@lakeread05...
You are using RG58 coax as a power lead????? Through a cigarette
lighter plug????

That is probably 99% of your problem. A 45W radio is probably drawing
10 amps or so. You need to completely rewire the power lead using at
least 12 ga wire (NOT COAX). It needs to be fused on BOTH leads AT THE
BATTERY. A cigarette lighter power connection should not be used for
more than 3-4 amps.

I would suggest you get with someone experienced an knowledgeable about
installing communications equipment in vehicles and get their guidance.

I would be surprised if your VCO even locked up when you were running
high power.

Dan wrote:
12 feet of RG58, plugged into the cigar lighter using one of those
radio shack adapters. I tried hooking it directly up to the battery
and had the same problem. Also hooked it up to a 10Amp power supply.



Nitespark wrote in message news:XHKlc.38165$NZ4.16447@lakeread05...

Dan wrote:


I just got my first mobile, a used HTX-212 (45W on high power).. When
I have the car engine off the transmit bars only light up about half
way. When I drive they go up farther but I still have trouble hitting
the repeater while my HT hits it with no problem. Are these power
fluctuations normal?

Thanks,
Dan
KE5BCC

What is the gauge of wire (for power) you have feeding the
transciever??? and how long???

Where is your power lead hooked in??? Is it hooked into the battery or
do you have it running through the fuse panel????