On Dec 21, 6:26 am, wrote:
Dear All,

I have some beginners questions regarding antennas:

*** Why is it difficult to design and construct HF transmit antennas
for high power PEP, compared with low power 100 W?
Conceptually what is the difference between the two in design,
material construction?
Why do people find the high power harder to design and construct?

*** I understand that omnidirectional antennas transmit in all
directions with almost equal gain. Is it hard to design HF antenna
with directional gain in one direction and minimum in other
directions?
How is this done( conceptually): electrical length, material
contruction?

*** HF wire antennas: can these be for high power transmission and
directional gain ( guess the would always be omnidirectional)?

*** How is angle of transmission with the horizon (elevation)
controlled in a HF antenna ?

*** Can receive antennas also be diectional or are they always
omnidirectional receiving from all sides?
Do receive antennas have power ratings?

Thank you

Vijay

It is very simple.

Voltage.

The higher the power the higher the voltage.
100W into 75ohms gives 86V.
200W @ 75 Ohms = 122V
500W @ 75 Ohms = 196V
1000W @ 75 Ohms = 273V

The current also goes up with power.

Higher voltage mean heavier duty construction.

The voltage show are at the terminals of a simple dipole.
The voltages at the ends of a dipole will be much higher.
Receiver antennas don't have power ratings.

Although the local 146.76MHz repeater has 5W from a
collocated FM BCB at the diplexer input.

The "National Electric Code" has some requirements
for receive antenna conductor size that no one bothers
with. I don't have my set of NEC rules handy, but the
wire size was picked for mechanical strength rather then
power handling capacity.

Terry