AI4QJ wrote:
"Bryan" wrote in message
...

Suzy wrote:

Looking for a website that gives comparative performance of diodes (max
frequency for UHF use)

A recollection from decades back are the 1N21, 1N23, 1N32, 1N53, 1N60, and
1N78 point-contact silicon diodes that were used as mixers well into the
microwave spectrum. Googling 1N23 produces 8000+ hits... including a
"Simple 2.4 GHz SWR Meter": (http://www.qsl.net/n9zia/24swr/index.html). I
see RF Parts (http://www.rfparts.com/) sells the 1N21 and 1N23.
MicroMetrics (http://www.micrometrics.com/) makes them, as well as various
schottky diodes suitable for sampling.
73,
Bryan WA7PRC


Interesting but this is not what was requested.




I don't think you'll find a website that compares diodes for RF
performance.

A couple reasons spring to mind:
1) Most RF designers have their favorite parts that they've used before,
so they will tend to just use them again. If their favorite part
doesn't work, then they'll start hunting through the pile of datasheets
and books or ask around for suggestions (e.g. just like on this list)

2) The performance is highly application specific. You can look at the
basic numbers (PIV, forward resistance, capacitance, etc.) to get an
idea, but it's really going to come down to how it works in YOUR
circuit, and that's usually a breadboarding or modeling exercise (most
parts have pretty good SPICE or other models available). Just because
manufacturer X's 1n5711 works great in my mixer doesn't mean it will
work great in your frequency tripler or someone else's RF switch.

3) There are significant differences in performance between
manufacturers for the same JEDEC partnumber (e.g. 1n5711). In a lot of
high performance applications, you actually depend on some non-datasheet
performance property. For instance, there's a small company in England
that makes a low noise JFET that is unique in the world and prized by
folks building charge/voltage converters, even though it's got a
standard 2N number. And then, they still get a batch of them and hand
select.

4) Parts selection is something of competitive value. Someone who
designs RF stuff for a living (i.e. someone who would be likely to know
all the trade offs between various part types and mfrs and could
generate a comparative website) is going to be encouraged by their
employer to not publish this for the whole wide world.