John,

Thanks for the reply. I'm actually interested in the version
of the formula (Rl = Vcc^2 / 2Pout) listed on page 2.33
of "Experimental Methods in RF Design", by Wes Hayward, ...
(excellent book).

In the example Vcc is 12 volts and Po is 1.5 watts. Rl
works out to 48 ohms. Wouldn't the peak current be
12 volts/48 ohms = 250 ma? If this were a sine wave then
the RMS power would be 1.5 watts. However, the amplifier
is run as Class C and only produces output less than half
of the time, so the output would then be less than 0.75 watts.

It seems that the formula should be adjusted to account
for the conduction angle, e.g. Rl should be smaller by at
least a factor of 2 to compensate for the conduction
angle. What am I missing?

Thanks,
Bruce Raymond/ND8I


"John Popelish" wrote in message
...
Bruce Raymond wrote:

I've seen the equation Po = V^2 / 2R applied to the design
of Class C amplifiers. This doesn't make sense to me and
I'm looking for corroboration, or somebody to tell me I'm
an idiot ;-). The formula makes sense for a Class A amplifier
which has conduction over 360 degrees, but would seem
to overstate the power output for a Class C amplifier with,
say a 120 degree conduction.

An amplifier with a 120 degree conduction angle would
only produce about 47% as much power as one with a
360 degree conduction angle (if I did the math right).
Therefore, I'm assuming that the formula should be
Po = .47 * V^2 / 2R, or Po = V^2 / 4.2R in this case.
Is this correct?


I think the answer depends on what the letter V stands for in the
equation. If it is the peak voltage of a sine wave that rings out of
a tuned circuit (or any other pretty good sine source), then it
doesn't matter how the sine wave was generated. Somehow, the energy
put into the resonator is driving a resistor with positive and
negative peak swings and that dumps
V^2 / 2R watts into the resistor. The instantaneous peak power put
into the resonance must be higher than that, for the class C amplifier
to pump it up to that voltage in a small fraction of a cycle.

If you want a challenge, figure the power out of a class C DC
amplifier.

--
John Popelish