Sorry Richard. Did not mean to alarm you. In fact there has been some doubt
about whether the material in the AR88 caps is PCB and indeed there's even
some controversy about how dangerous PCB is. But I personally (nervous
fellow that I am) prefer to play safe. I even have cards all over my
workbench reminding me that there are lethal voltages in an AR88. Trouble
with modern electronics is we get used to handling 5volts with impunity and
it is as well to rekindle the caution we used to apply (or should have) in
the valve days. For those who want to read up on PCBs try the writings of
Barry Ornitz who is a very knowledgeable chemical engineer.

"MoiInAust" wrote in message
...
Thanks Richard

But not only does it smell bad, it is positively dangerous! Believed to
be PCB oil which is carcinogenic. (BTW, they are not electrolytic but oil
filled paper caps). I have received comprehensive advice on disposing of
the leaky capacitors (should I say condensers?) safely and in accordance
with health regulations. They MUST not be just thrown into the gargbage. I
will be removing mine according to that advice. Either I will obtain
genuine replacements or I will have to do with tagstrips and indivdual
caps. Ouch! I know that's sacrilege but its the lesser of the two evils if
new 'originals' can't be found --- and by the way I may have found them!

"Richard Knoppow" wrote in message
m...

"MoiInAust" wrote in message
...

"Firebottle3" wrote in message
...
On Jun 28, 8:07 pm, "MoiInAust" wrote:
Are there any AR88 enthusiasts in Australia on this group?

Anyone (in any country) know anything about the RAF variant (R1156A I
believe)? It appears the same as the normal one except has an earthing
plug
for the mute fitted to the rear (a plque syas fopr the Control Unit
type
88). I've just acquired one with leaking bathtub condensers.

Where do the AR88 people hang out please?

Look he http://mailman.qth.net/

Click on directory scroll down to RCA join for free or look at the
archives.

Thanks Tor and Richard

I was aware of both!
The bathtub caps can often be "rebuilt" if you want something
original looking. You need a large soldering iron to get the bottom off.
It isn't a matter of heat but of mass to be able to get the thing off.
They were probably soldered on by dipping in a solder pot. Once the
bottom is off you can melt out the potting compound. Most of this is a
wax mixture which will flow out. Most of it smells pretty bad so do this
outside. The original cap can then be removed and replaced with a modern
one. That can be held in place with a bit of silicon rubber or even some
of the original potting compound melted back in. The bottom can be tacked
back with the soldering iron.
I think this is a lot of work in the interest of appearance but a lot
of people care about that.
If you have one bad electrolytic look our for others of the same
type.



--
Richard Knoppow
Los Angeles
WB6KBL