"Kenneth Scharf" wrote in message
...
Many years ago a friend of mine was repairing a Heath SB200 linear he had
picked up. The antenna relay needed work and he was replacing the stupid
RCA connector in the input side of the rig with an SO-239 (why did Heath
use those RCA connectors for the antenna in all their ham rigs?).

Anyway we were talking about how the linear improved the transmit signal
strength, but did nothing for the receiver and he wanted to also build a
small receiver preamp to put inside the linear cabinet, and we both got
the samw brainstorm, at the same time. Why not wire the linear up so it
would work in BOTH directions? I suppose a grounded grid preamp using
tubes with a combined plate dissipation of some 300 watts seems crazy, and
one's first though would be "you'll blow up the receiver!". But remember
that those tubes have a power gain of only 13db and that's about the same
as a 6BA6 rf amp tube. Of course the noise figure of the 572B as a preamp
probably isn't quit as good as a 6CW4, but you won't notice it much on 20
meters. Also at the signal levels we are talking about the usual cutoff
bias for the tubes STILL leaves them in class A for use as a small signal
preamp!

To make a long story short, we wired the relay up so it would do the
required switching and tried it. The linear did boost received signals by
about 13db, just as we expected. Made a difference in the DX contest!

Now that's really, really scary!

Old Chief Lynn, W7LTQ