BCD396XT car charger
John Kasupski wrote in
:
On Sat, 04 Dec 2010 11:34:51 -0600, randiR
wrote:
i have a car charger that recently causes my scanner to display
'iilegal voltage'. so i took out the fuse and it is a F250v 2A. Before
I go out and buy a new fuse (not knowing that is in case the issue),
is this fuse in fact strong enough for this radio? I always heard
8000mah was minimum. any ideas/comments?
Well, a fuse regulates current, not voltage, and it does so by
breaking the circuit when too much current flows through it. The fact
that you said the charger "recently" causes the radio to display the
illegal voltage notification leads me to believe that previously, you
have used this charger without any problem, so the question becomes,
what has changed since then that has in turn changed the voltage the
scanner is seeing?
So if your scanner is telling you there's something wrong with the
voltage, you should first check the voltage being supplied by the
charger - which can be done with a simple multimeter. The most common
problems are a connector that's loose, or shorted, or the safety clip
that holds the connector together is broken, but some component of the
charger itself may have recently failed and now be defective - in
which case you need a new charger, not a new fuse.
You might also want to check the voltage of the vehicle's electrical
system, which can drop too low when you're running the
heater/defroster on full blast, using the windshield wipers, etc.
Various problems in a vehicle's electrical system which can cause
voltage drops should be handled by your usual repair shop unless
you're handy with automotive electrical repairs. The voltage can also
be too high, as often happens when there's something wrong with the
vehicle's volrage regulator - and a defective voltage regulator can
also drastically shorten the life of your vehicle's battery so if this
is the problem you'll want to get that fixed ASAP!
Hope this helps.
John, W2PIO
Tonawanda, NY
thank you. helps a great deal.
|