On Feb 20, 12:39*pm, John Larkin
wrote:
On Sun, 20 Feb 2011 09:20:12 -0600, "amdx" wrote:
Hi all,
I finished the amp that had the 5 Ghz transistor, I changed it to a slower
one.
The objective of this amp is to cause minimal loading of the circuit it is
measuring.
When I install the box cover the voltage gain drops by 7%, so I think the
input capacitor
plate is being loaded by the cover.
The input capacitor plates can be seen here;

http://i395.photobucket.com/albums/p...mspaced5mm.jpg

The plates are 1 cm x 1 cm spaced 5 mm apart.

I have thoughts about *rectangular plates 0.25 cm x 4 cm to get more
distance from the top cover, (and the bottom.)
Or a real gimmick cap where I twist a couple of 39 Gauge wires together and
attach opposite ends to input and output.

*Any ideas to minimize input capacitance to the box?

Here's the amp in box.
http://i395.photobucket.com/albums/p...erampinbox.jpg

This is the original circuit page with schematic;
http://www.crystal-radio.eu/enfetamp.htm
* * * * * * * Thanks, Mike

PS, I was having trouble getting some close-up pictures, I grabbed a
magnifying glass and took some
pictures through that, works good.

Use a real surface-mount 0.3 pF cap, or a homemade coaxial cap. The 1
cm square plates are too big and have their own capacitance to the
world.

For that matter the tiny input cap in Mike's circuit is
counterproductive--it divides the signal down and makes the gain
unpredictable.

Better: use 10pF coupling, lose less at the input, and use less gain
later. Bootstrap the FET so the input sees very low C. Do those and
you don't even need a gimmick.


Bootstrap the drain of Q1.

"T" means transformer, which shows that this circuit was done by an
amateur. All that tricky stuff could be replaced by one opamp.

It could have close to zero Cin with a little positive feedback.

John

I like the one at the top of pg. 2:
http://www.national.com/an/AN/AN-32.pdf

1970--a classic.


--
Cheers,
James Arthur