On Fri, 07 Jan 2005 08:24:20 -0600, Cecil Moore
wrote:

Dhakala wrote:
Thanks for the advice. Why would it be easier to cut the insulation
from the inside of 300 ohm ladder-line wire than from flat antenna wire?

Because more than half has been chopped out already. You can cut
the ladder-line at a place where there's no center insulation and
have one inch wire tails needing only a wire stripper. If you
need longer wire tails than that, you only need to cut out about
1/4" of center insulation with an Exacto knife to achieve two inch
wire tails.

I have an Exacto knife, but find a no. 199 Stanley box cutter, with
its bigger blade, a good tool for something like this. Either way, it
only takes a couple of seconds...

THere's probably a special stripper for 300-ohm line, but it probably
costs a pretty penny, too.

Bob
k5qwg