Home |
Search |
Today's Posts |
#1
![]() |
|||
|
|||
![]()
I'm the proud owner of a nice SP-600, unfortunately it is without tags, can
someone help me to identify wich version I have? Here below some details: -Non-mil radio no yellow anti-fungus varnish at all; -Disc capacitors, no black beauty; -The antenna connector looks to have been factory modified to an SO-239 style to accept coax cable; -Crystal deck with crystals -Dial lock -Gray front panel, white letters engraved. thank you Claudio |
#2
![]() |
|||
|
|||
![]() "moreradio" wrote in message .. . I'm the proud owner of a nice SP-600, unfortunately it is without tags, can someone help me to identify wich version I have? Here below some details: -Non-mil radio no yellow anti-fungus varnish at all; -Disc capacitors, no black beauty; -The antenna connector looks to have been factory modified to an SO-239 style to accept coax cable; -Crystal deck with crystals -Dial lock -Gray front panel, white letters engraved. thank you Claudio This is not enough information. There is a great deal of information on the web, do a Google search for sp 600 jx to find it. There were more than twenty variations of the SP-600 made, most nearly alike. The total production was on the order of 25,000 units. Your description fits most of the receivers with exception of the VLF special, the JX-17 (has two extra switches and three small red knobs) and those made without the fixed frequency crystal unit. All have very similar circuitry. The receivers should have a name plate on top of the tuning capacitor cover with serial number and version type on it. These are somtimes missing. The disc capacitors were used in receivers built after the mid fifties but a great many earlier receivers built with Sprague Black Beauty caps were modified due to the very high early failure rate of these caps. Also many receivers were modified to have the SO-239 connector rather than the balanced coax connector originally used. All of the JX-17s had these from the factory. I am pretty sure the anti-fungus treatment was applied after market and not all receivers have it. Actually this is an advantage if you have to work on the thing because the anti-fungus is very difficult to get off and often glues things together. At least one of the web sites has a list of versions although its not quite complete. -- Richard Knoppow Los Angeles WB6KBL |
#3
![]() |
|||
|
|||
![]() "Richard Knoppow" wrote in message m... "moreradio" wrote in message .. . I'm the proud owner of a nice SP-600, unfortunately it is without tags, can someone help me to identify wich version I have? Here below some details: -Non-mil radio no yellow anti-fungus varnish at all; -Disc capacitors, no black beauty; -The antenna connector looks to have been factory modified to an SO-239 style to accept coax cable; -Crystal deck with crystals -Dial lock -Gray front panel, white letters engraved. thank you Claudio This is not enough information. There is a great deal of information on the web, do a Google search for sp 600 jx to find it. There were more than twenty variations of the SP-600 made, most nearly alike. The total production was on the order of 25,000 units. Your description fits most of the receivers with exception of the VLF special, the JX-17 (has two extra switches and three small red knobs) and those made without the fixed frequency crystal unit. All have very similar circuitry. The receivers should have a name plate on top of the tuning capacitor cover with serial number and version type on it. These are somtimes missing. The disc capacitors were used in receivers built after the mid fifties but a great many earlier receivers built with Sprague Black Beauty caps were modified due to the very high early failure rate of these caps. Also many receivers were modified to have the SO-239 connector rather than the balanced coax connector originally used. All of the JX-17s had these from the factory. I am pretty sure the anti-fungus treatment was applied after market and not all receivers have it. Actually this is an advantage if you have to work on the thing because the anti-fungus is very difficult to get off and often glues things together. At least one of the web sites has a list of versions although its not quite complete. -- Richard Knoppow Los Angeles WB6KBL FWIW; I have an SP600 with the JX17 designation on the the tuner cover. It has the balanced coax antenna connector, and coverage from 540 kHz to 54 mHz, and no red knobs. Of course, there's always the chance of a swap of tuner covers... Nelson |
#4
![]() |
|||
|
|||
![]() "Nelson" wrote in message ... "Richard Knoppow" wrote in message m... "moreradio" wrote in message .. . I'm the proud owner of a nice SP-600, unfortunately it is without tags, can someone help me to identify wich version I have? Here below some details: -Non-mil radio no yellow anti-fungus varnish at all; -Disc capacitors, no black beauty; -The antenna connector looks to have been factory modified to an SO-239 style to accept coax cable; -Crystal deck with crystals -Dial lock -Gray front panel, white letters engraved. thank you Claudio This is not enough information. There is a great deal of information on the web, do a Google search for sp 600 jx to find it. There were more than twenty variations of the SP-600 made, most nearly alike. The total production was on the order of 25,000 units. Your description fits most of the receivers with exception of the VLF special, the JX-17 (has two extra switches and three small red knobs) and those made without the fixed frequency crystal unit. All have very similar circuitry. The receivers should have a name plate on top of the tuning capacitor cover with serial number and version type on it. These are somtimes missing. The disc capacitors were used in receivers built after the mid fifties but a great many earlier receivers built with Sprague Black Beauty caps were modified due to the very high early failure rate of these caps. Also many receivers were modified to have the SO-239 connector rather than the balanced coax connector originally used. All of the JX-17s had these from the factory. I am pretty sure the anti-fungus treatment was applied after market and not all receivers have it. Actually this is an advantage if you have to work on the thing because the anti-fungus is very difficult to get off and often glues things together. At least one of the web sites has a list of versions although its not quite complete. -- Richard Knoppow Los Angeles WB6KBL FWIW; I have an SP600 with the JX17 designation on the the tuner cover. It has the balanced coax antenna connector, and coverage from 540 kHz to 54 mHz, and no red knobs. Of course, there's always the chance of a swap of tuner covers... Nelson The JX-17 was intended for diversity operation and has connectors for the IFO (second conversion oscillator) with a switch on the front and the BFO, also with a switch and aso a connector on the fixed frequency assembly to use an external HFO. This has an additional position on the crystal-VFO switch. It has some other minor changes to the circuitry: a different BFO circuit and fixed crystal circuit, and the BFO injection level is fixed so it does not have the injection pot on the back. These receivers were made with the coaxial antenna connector rather than the balanced connector used on other models, however many receivers were modified to use the coax connector. Its not a difficult mod but requires a lot of work. Evidently, a lot of receivers were modified for diversity reception with unsatisfactory results so Hammarlund decided to offer a factory version. Most JXs, however have means for more simple diversity work, namely an IF output and access to the AVC and Detector lines. If you want very high quality audio connect an external amplifier to the detector terminals (needs a DC blocking capacitor and is rather high impedance). The detector itself has quite low distortion. However, note that the normal AVC time constant is so fast that the level will vary with low frequency modulation. The cure is to run it in manual RF gain or to hang a rather large cap (a couple of microfarads) across the AVC terminal on the back. This is why the RF level meter bounces with modulation, it is measuring carrier level. A last note: The SP-600 is a very good receiver but I think a lot of them are working but sick. The freqency calibration and RF tracking should be very good but I think the mechanical alignment of the tuning capacitor drifts with time so a lot of them are not longer properly aligned. The stators are held onto the frame with three clamp screws. The stators should be exactly parallel to the rotor and exactly centered. Also vertical alignment should be exact with the edges of the rotor and stator plates in line when the cap is closed. NEVER bend plates. Even though the end plates are slotted they were never meant to be adjustable that way. Once they are bent it is extremely difficult to ever get them straight again and the stress will eventually break the plates off the shaft. Proper mechanical alignment requires removing the tuning cap. This is a lot of work but not really difficult. -- Richard Knoppow Los Angeles WB6KBL |
#5
![]() |
|||
|
|||
![]()
In om on Sun, 1 Nov
2009 15:08:24 -0800, in rec.radio.amateur.boatanchors, 'Richard Knoppow' wrote: The JX-17 was intended for diversity operation and has connectors for the IFO (second conversion oscillator) Just out of interest, how long has diversity encoding been around? I thought of it as relatively modern, and I've only read about it from the POV of digital signals. Is there anywhere anyone'd recommend for a bit of research? Something semi chronological would be nice. Dave J |
#6
![]() |
|||
|
|||
![]()
On Sat, 7 Nov 2009, Dave J. wrote:
In om on Sun, 1 Nov 2009 15:08:24 -0800, in rec.radio.amateur.boatanchors, 'Richard Knoppow' wrote: The JX-17 was intended for diversity operation and has connectors for the IFO (second conversion oscillator) Just out of interest, how long has diversity encoding been around? I thought of it as relatively modern, and I've only read about it from the POV of digital signals. Is there anywhere anyone'd recommend for a bit of research? Something semi chronological would be nice. It goes back to the thirties, at least. Hallicrafters had a diversity receiver back then, I have no idea how many were sold. There was an article in "Ham Radio" decades ago about diversity and specifically about that Hallicrafters radio. Looking at an accumulated index, I think it was the April 1980 issue. But, there was a history of Hallicrafters in the same issue, and that one (from the same accumulated index) is supposed to be in the Nov 1979 issue, which makes more sense since for a long time the magazine devoted the November issue to receivers. Michael VE2BVW |
#7
![]() |
|||
|
|||
![]()
Dave J. wrote:
Just out of interest, how long has diversity encoding been around? I thought of it as relatively modern, and I've only read about it from the POV of digital signals. Is there anywhere anyone'd recommend for a bit of research? Something semi chronological would be nice. Back to the thirties at least. Earlier diversity systems were comparatively crude, though, normally just looking at two antenna systems separated in space or in polarization and picking the one with the higher AGC voltage. This can give a remarkable improvement in dealing with ionospheric fading, though. Was standard practice for remote shortwave links on broadcast networks. --scott -- "C'est un Nagra. C'est suisse, et tres, tres precis." |
#8
![]() |
|||
|
|||
![]() "Scott Dorsey" wrote in message ... Dave J. wrote: Just out of interest, how long has diversity encoding been around? I thought of it as relatively modern, and I've only read about it from the POV of digital signals. Is there anywhere anyone'd recommend for a bit of research? Something semi chronological would be nice. Back to the thirties at least. Earlier diversity systems were comparatively crude, though, normally just looking at two antenna systems separated in space or in polarization and picking the one with the higher AGC voltage. This can give a remarkable improvement in dealing with ionospheric fading, though. Was standard practice for remote shortwave links on broadcast networks. --scott -- "C'est un Nagra. C'est suisse, et tres, tres precis." Space diversity is indeed that old but there were some fairly sophisticated methods such as the Bell Labs MUSA Multiple Unit Steerable Antenna which could be varied in vertical angle electrically. RCA was using triple space diversity receiving systems at the Riverhead N.Y. receiving station in the 1930s. I suspect one could find a lot of literature in the old Jornal of the IRE and probably also the Bell Labs Technical Journal and RCA Review although I don't have specific citations. Around the 1950s Leonard Kahn and others worked out means of combining the sidbands of a conventional AM or double sideband suppressed carrier signal using a synchronous detector. In effect this was a sort of frequency diversity. It also reduced distortion due to selective fading since it regenerated the carrier locally. -- Richard Knoppow Los Angeles WB6KBL |
#9
![]() |
|||
|
|||
![]()
On Sat, 7 Nov 2009, Richard Knoppow wrote:
Around the 1950s Leonard Kahn and others worked out means of combining the sidbands of a conventional AM or double sideband suppressed carrier signal using a synchronous detector. In effect this was a sort of frequency diversity. It also reduced distortion due to selective fading since it regenerated the carrier locally. Wasn't it Webb at GE that was doing the work on DSB? That's the name on the synchronous detector article in "CQ" in the late fifties, and that was either preceeded or followed by an article about DSBsc in general. And John Costas of course came up with the Costas Loop for receiving AM, and I see he was at GE in the fifties when he came up with the Loop. Michael VE2BVW |
#10
![]() |
|||
|
|||
![]()
Diversity is certainly not a new concept. It was present in the RCA AR88
designed about 1938-9! "Dave J." wrote in message ... In om on Sun, 1 Nov 2009 15:08:24 -0800, in rec.radio.amateur.boatanchors, 'Richard Knoppow' wrote: The JX-17 was intended for diversity operation and has connectors for the IFO (second conversion oscillator) Just out of interest, how long has diversity encoding been around? I thought of it as relatively modern, and I've only read about it from the POV of digital signals. Is there anywhere anyone'd recommend for a bit of research? Something semi chronological would be nice. Dave J |
Reply |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
WTB:EasySpan Version 2.2.1 Full Version. Not Demo. | Swap | |||
Trying to Identify?? | Antenna | |||
Can anyone identify this... | Shortwave | |||
Help identify this amp... | CB | |||
Please Identify | Broadcasting |