For sale:

Icom 207H dual band mobile.

Price:

$200, $15.00 ship airborne ground, Continental US Only.

If interested please email me at jppc at mindspring dot com.

Included:

Radio,
Mic,
Power cord,
Reprint of manual.

Modified as follows:

118-135 RX (stock)
136-174 TX & RX
320-399 RX
400-479 TX & RX
849-950 RX
(Perforance out of ham bands not tested or guaranteed.)

Factory specs below:

This information is taken directly off of the Icom IC-207H brochure.

General
a.. Frequency coverage (Unit: MHz)
a.. VHF: Tx: 144-148 Rx: 118-174 *1
b.. UHF: Rx/Tx: 440-450
c.. *1 Guaranteed 144-148
b.. Mode: FM, AM* (* U.S.A. version, RX only; 118-136 MHz; not
guaranteed.)
c.. Number of memory channels: 182 (150 reg., 2 call, 10 scan edges
and 20 scratch pads)
d.. Antenna connector :SOI-239 (50 ohms)
e.. Power Supply requirement : 13.8 V DC +/-15%
f.. Useable temperature range : -10°C to +60°C; +14°F to +140°F
g.. Frequency stability: +/-10 ppm
h.. Tuning step increments: 5, 10, 12.5, 15, 20, 25, 30 and 50 kHz
i.. Current drain (at 13.8 V DC)
a.. Receive squelched 0.8 A
b.. max. audio output 1.0 A
c.. Transmit at high power VHF 12A UHF 11A
j.. Dimensions (projections not included):
a.. 140(W) x 40(H) x 185.4(D) mm
b.. 5 1/2(W) x 1 9/16(H) x 7 5/16(D) in
k.. Weight: Approx. 1.17 kg; 2.6lb.


Transmitter
a.. Output power:
a.. VHF 50 W, 20 W, 10 W, 5 W selectable
b.. UHF 35 W, 20 W, 10 W, 5 W selectable
b.. Modulation system : variable reactance frequency modulation
c.. Max. frequency deviation : +-5.0 kHz
d.. Spurious emissions : Less than -60 dB
e.. Microphone connector : 8-pin modular jack (600 ohms)


Receiver
a.. Receive system: Double conversion superheterodyne
b.. Intermediate frequencies: 1st 46.05 MHz, 2nd 450 kHz
c.. Sensitivity: Less than 0.18 micro V for 12dB SINAD
d.. Squelch Sensitivity: 0.13 micro V (at threshold)
e.. Selectivity :
a.. More than 12kHz/ -6 dB
b.. Less than 30 kHz/ -60dB
f.. Spurious rejection ratio: More than 60 dB
g.. Audio output (at 13.8 V DC): More than 2.0 W at 10% distortion
with an 8-ohm load
h.. Ext. speaker connector: 2-conductor 3.5(d) mm (1/8")/ 8 ohms


Supplied accessories:
a.. Hand microphone
b.. Mobile mounting bracket kit
c.. DC power cable
d.. Spare fuse


Options
SEPARATION ACCESSORIES
a.. OPC-600/601 SEPARATION CABLE For operation with the front panel
detached. OPC-600: 3.5m (11.5ft); OPC-601: 7.0m (23.0 ft)
b.. MB-58 REMOTE CONTROLLER BRACKET Mounts the remote controller in
a convenient location for operation with the front panel detached.
c.. MB-65 REMOTE CONTROLLER BRACKET Mounts the remote controller
with the MB-58. Adjustable angle and direction for optimum positioning.
d.. OPC-346/OPC-347 DC POWER CABLE Has a 20 A capacity and a length
of 3/7 m (9.8/23ft).
e.. OPC-440/647 MIC EXTENSION CABLE
f.. OPC-440: 5.0m (16.4ft); OPC-647: 2.5m (8.2ft)
g.. OPC-441 SPEAKER EXTENSION CABLE 5.0m (16.4ft)
WIRELESS REMOTE ACCESSORIES

a.. HM-90 WIRELESS MICROPHONE Infrared, full remote control
microphone. Wired remote control is also possible.
b.. EX-1759 INFRARED RECEIVER Used to receive control signals from
the HM-90
c.. BC-96 MICROPHONE HOLDER Holds the HM-90 in a convenient place
and supplies power to the charging circuit of the HM-90.
d.. CP-13/L CIGARETTE LIGHTER CABLE WITH NOISE FILTER
e.. OPC-288/L CD POWER CABLE Supply power to the BC-96 for charging
the Ni-Cd batteries inside the HM-90.
f.. EX-1513 INFRARED SUB RECEIVER Used with the EX-1759 to extend
the controllable area.
OTHER ACCESSORIES

a.. CS-207 CLONING SOFTWARE + OPC-646 CLONING CABLE For quick and
easy programming of memories, etc.
b.. HAND MICROPHONES HM-77(w/DTMF memory)HM-78, HM-79(w/tone
call)HM-95(w/DTMF)HM-96, HM-97(w/tone call) andHM-98 (remote control)
c.. HS-62FLEXIBLE MOBILE MICROPHONE + HS-15SB SWITCHBOX
+OPC-589ADAPTER CABLE For all-around mobile operation.
d.. MB-17A MOBILE MOUNTING BRACKET
e.. SP-10/SP-12 EXTERNAL SPEAKERS