| Home |
| Search |
| Today's Posts |
|
#1
March 8th 07, 03:27 PM
posted to rec.radio.amateur.antenna
|
|||
|
|||
Connections to an antenna
I'm building the WA5VJB "cheap yagi" antenna. Other than soldering,
what are some simple methods/materials for attaching the center wire and braid to 1/8 inch diameter driven element. I figure there must be a magic clamp, strap, electrical connector, etc. out there somewhere... TIA. Bill W2ET |
|
#2
March 8th 07, 05:20 PM
posted to rec.radio.amateur.antenna
|
|||
|
|||
|
Connections to an antenna
"wbickle" wrote in message ps.com... I'm building the WA5VJB "cheap yagi" antenna. Other than soldering, what are some simple methods/materials for attaching the center wire and braid to 1/8 inch diameter driven element. I figure there must be a magic clamp, strap, electrical connector, etc. out there somewhere... TIA. Bill W2ET Hi Bill When I use aluminum rod for driven elements, I thread the end of the rod then use two nuts to squeeze the wire between them. 0.125 OD will require a small die. Jerry |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Wiring SMA connections | Antenna | |||
| Radial connections | Antenna | |||
| PS connections for NCX-3 | Boatanchors | |||
| FT-480R mic connections | Equipment | |||
| FT-480R mic connections | Equipment | |||
Linear Mode
