| Home |
| Search |
| Today's Posts |
|
#1
October 22nd 16, 12:18 AM
posted to rec.radio.amateur.antenna
|
|||
|
|||
Question about LMR-200 and N connectors
I'm putting up a discone for UHF/VHF and have settled on LMR-200 as a good
performance/size compromise cable. I have some W5SWL crimp on N conectors for this cable. I'm wondering what dimension the crimping tool die should be for crimping on the center pin. I thought it was suppposed to be 0.100 inch, but that's too big. Anyone know the correct crimp dimension? -- Lee K. Gleason N5ZMR Control-G Consultants lee.gleason@comcastnet --- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus |
|
#2
October 22nd 16, 11:39 PM
posted to rec.radio.amateur.antenna
|
|||
|
|||
|
Question about LMR-200 and N connectors
On Friday, October 21, 2016 at 6:18:41 PM UTC-4, Lee Gleason wrote:
I'm putting up a discone for UHF/VHF and have settled on LMR-200 as a good performance/size compromise cable. I have some W5SWL crimp on N conectors for this cable. I'm wondering what dimension the crimping tool die should be for crimping on the center pin. I thought it was suppposed to be 0.100 inch, but that's too big. Anyone know the correct crimp dimension? -- Lee K. Gleason N5ZMR Control-G Consultants lee.gleason@comcastnet --- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus Why not solder it? |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
