Hi All,
I have a rotating Flag antenna. I'm rebuilding it so the horizontal
beam will rotate vertically. This will allow me to install new parts while
I'm standing on the ground. I hope this will make experimenting easier.
I have a pin that locks the beam 90 degrees to the mast. By drilling
another
hole I can make that any angle. Please see post "Flag Antenna Rotation"
in ABSE.
The question;
Is there any change in the pattern caused by tilting the Flag antenna?

Can someone familiar with Eznec run a case with the antenna
tilted 20 degrees from horizantal?

Thanks for any info,
Mike