| Home |
| Search |
| Today's Posts |
|
#1
February 1st 05, 12:27 PM
|
|||
|
|||
WTB: 90 Degree drive assembly
Typically used for tuning most anything at 90 degrees from straight out
shaft. 1/4" shafts, can use 2 to 4 if you have...Old Mil also considered. al |
|
#2
February 1st 05, 12:49 PM
|
|||
|
|||
|
The output shaft/gear-box from an old angle-grinder?
"AL G." wrote in message ... Typically used for tuning most anything at 90 degrees from straight out shaft. 1/4" shafts, can use 2 to 4 if you have...Old Mil also considered. al |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| WTB Lafayette KT-200 Assembly Manual | Boatanchors | |||
| FA: Heath Heathkit SB SB-610 Monitor Scope Assembly Manual | Dx | |||
| FA: Heath Heathkit SB SB-610 Monitor Scope Assembly Manual | Equipment | |||
| FA: Heath Heathkit SB SB-610 Monitor Scope Assembly Manual | Boatanchors | |||
| FA: CDROM drive for older Laptops | Swap | |||
Linear Mode
