Home |
Search |
Today's Posts |
#17
![]() |
|||
|
|||
![]() I have put an old Allen wrench into a stuck slug and heated it with a large soldering iron, then carefully remove the slug by turning the Allen wrench with a pair of pliers while the slug was warm enough to melt the wax. That's a good way of transferring the heat. But care must be taken not to tork the allen wrench too much. I've broken far too many slugs with those inflexible steel tools. One other thing, some coils are sealed with "Printer's Ink", a water based ink that chips easily. We used it on all the coils in the PRC-77 radios built by CE. Thanks for that reminder. Forgot about some water soluble sealers. You have to be careful drilling holes in circuit boards. I have worked on a lot of RF boards with traces run under coils that will be destroyed with a drill bit. That's a given, that care must be taken where you drill. I've never damaged a trace yet, though I've opted not to drill some. Of course if the board has internal traces (sandwich) forget it!! Ed |
Thread Tools | Search this Thread |
Display Modes | |
|
|