About Us

[email protected]

In rec.radio.amateur.equipment dave wrote:
wrote:
In rec.radio.amateur.equipment dave wrote:
wrote:

A 5db T attenuator with 15 W in has the maximum dissipation in the shunt
resistor at about 5 W.

The input series resistor dissipates about 4 W and the output series
resistor dissipates a little over 1 W.

I see no reason to go to wirewound resistors at these power levels.

What kind of 5 Watt resistors should I use?

Just about anything you can get other than wire wound.

Mouser has metal oxide 5 W resistors for $0.49 quantity 1.

You don't really want to run them at full rating but you will likely
have to parallel two to get the values you need anyway unless you have
a cheap source of better than 5 W precision resistors.

You need two 14.01 Ohm resistors and one 82.24 Ohm resistor to build
the attenuator.

If you parallel two 27 Ohm for 13.5 Ohm, and two 150 ohm for 75 Ohm, you
wind up with an attenuation of 4.95 db and a VSWR of 1.04 for a 50 Ohm
system.

Thanks, Jim. The thing works like a champ. I added a couple of $2.00
relays to bypass the pad when receiving.

Good to hear I didn't drop a decimal...

--
Jim Pennino

Remove .spam.sux to reply.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NRD-515 MW attenuator	Pete KE9OA	Shortwave	1	November 22nd 07 10:09 AM
To build or not to build Part II	[email protected]	Homebrew	1	December 22nd 05 07:56 PM
Variable Attenuator	Gary Smith	Antenna	16	August 10th 05 08:33 AM
Testing an attenuator?	Ken	Antenna	9	March 27th 04 04:01 PM
FA: MFJ-762 Step Attenuator NR	Ken Bessler	Swap	0	November 21st 03 10:11 PM

Menu

About Us