Hi All,
I just ran across an old DSI 3600A frequency counter at an
auction for $1. I was hoping that I might be able to use this to help
check the alignment on my old Swan 500CX. Problem is, it had no
documentation with it and the only other freq. counter I have used was
a radio shack handheld one w/the BNC whip. It has a pair of unlabeled
PL-259 connectors on the backside. Only controls on the front side
are the direct /pre scale selector for the .1 or 1 sec. gate. Also
has an "oven" on it, which I am not quite sure what that exactly is.
Was wondering if anyone could comment on the use of this one. Sorry
to sound so non-electronics savvy for an amateur op, but any help
would be appreciated.


Thanks,
Sam Bradshaw
KB8ZZS.

The "oven" is for keeping a cup of coffee warm while talking on 160 meters
on a cold winter night....
Actually..the oven keeps the timebase osc. stable (once it gets to temp). 2
inputs...more than likely it has a direct and prescale input...Eddie

"Sam Bradshaw" wrote in message
om...
Hi All,
I just ran across an old DSI 3600A frequency counter at an......

KB8ZZS.

The "oven" is for keeping a cup of coffee warm while talking on 160 meters
on a cold winter night....
Actually..the oven keeps the timebase osc. stable (once it gets to temp). 2
inputs...more than likely it has a direct and prescale input...Eddie

"Sam Bradshaw" wrote in message
om...
Hi All,
I just ran across an old DSI 3600A frequency counter at an......

KB8ZZS.