I have just bought a Kenwood TS711A and its got a slight problem.
The 100hz digit on the main frequency readout,
and the RIT readout works fine when it reads 0, but as soon as I
tune off the 0, all the seven segments light up and it reads 8. This
makes it useless.

If I select a memory that has never had a frequency stored in it,
the 100hz digit reads 8 instead of the - that it should. example-
- - -. - - -.8. 8.0 when it should read
- - -. - - -.-. 0.0

I've tried a processor reset, but made no difference. Anyone got any
ideas?

--
Jack
VK2CJC (look up my email address using the usual sites)