Home |
Search |
Today's Posts |
#1
![]() |
|||
|
|||
![]()
Monkey chatter leaking in from adjacent stations is the bane of the
radio listener. It is most annoying and can badly interfere with the station you are trying to listen to. As radio's have got better over the years by using better circuitry and better filters, this problem is not as bad as it used to be many years ago. But it is still a problem, especially on cheaper portables. In the $100 price range, don't expect wonders, as even the Chinese manufacturers have to compromise quality and build DOWN to a budget price. My current best portable is my Redsun RP2100 (CC Crane SW & Kaito KA2100). It has a narrow and wide filter setting - narrow is about 10 kHz wide and "wide" is as broad as the sunny skies in mid summer. So it does let in monkey chatter from adjacent stations. This is because the ITU lays down a 5 kHz channel separation and unless you have a radio with top end circuitry and tight 5 kHz filters, then the adjacent channel is bound to break through. A top of the range portable like the Eton E1 has excellent filters (see Passport review) and will do a very good job of keeping the monkey chatter out of your desired signal. Top end tabletop communications receivers are even better. The more you pay the more you get. This makes general listening a lot more pleasurable and satisfying. But even with these top end radio's you may still get annoying monkey chatter and wonder why, and wonder if your radio has gone on the blink and if the filters are not working properly? The answer is NO, it is not your radio but badly adjusted transmitters spewing out splatter by way of a bad footprint and harmonics and artefacts. A transmitter is supposed to occupy no more than the 5 kHz assigned to it by the regulating authority, but with the advent of radio's with spectrum scopes it is possible to see exactly how much space a transmitter is occupying. A lot of them occupy 10 kHz and some even as much as 12 kHz. In one case: BBC Meyerton on 3255 kHz it was actually splattering 40 kHz above and 20 kHz below it's assigned frequency. Even if you have a $10,000 receiver like the Icom IC-R9500 you still won't get rid of that. Another example is 6150 kHz DW Kigali - it occupies a full 12 kHZ, making listening on the adjacent channels of 6145 and 6155 kHz quite impossible, even with my top end radio's. So next time you are plagued by monkey chatter, don't blame your own radio, as it may be a "dirty" transmitter spewing splatter well outside it's assigned channel range. Have fun, good DX and enjoy your radio's. John Plimmer, Montagu, Western Cape Province, South Africa South 33 d 47 m 32 s, East 20 d 07 m 32 s Icom IC-7700, Icom IC-756 PRO III with MW mods ERGO software Drake SW8. Sangean 803A Sony 7600D, GE SRIII, Redsun RP2100 Antenna's RF Systems DX 1 Pro Mk II, Datong AD-270 Kiwa MW Loop. http://www.dxing.info/about/dxers/plimmer.dx |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
FS:KENWOOD FILTERS/YAESU FILTERS | Swap | |||
FA TS 450 WITH DSP AND FILTERS FA | Equipment | |||
FA TS 450 WITH DSP AND FILTERS FA | Equipment | |||
FS: EMI/RFI filters | Swap | |||
FS: EMI/RFI filters | Swap |