I have a diode / filter cap power supply board for sale. Sold over
1000 since introduction 5 years ago. Now third generation board, clean
single board design. Uses top quality components, electrolytic cap is
2.2 times more than the original and the diodes are rated 3A 6000V PIV
in each leg. Bleeder resistors are 75K ohm / 6W each across caps.
Reduce heat substantially. No drilling or mod to the 30L-1 structure
for mounting. Sold for up to $99 by dealer. This is direct sale for
big savings. $59 each plus USPS shipping charge. 105 degree C high
temp upgrade version is $10 extra, free bias diode and electrolytic
caps included. Money back guarantee. Send e-mail for photos.
The board is one board design, completed and tested but the photo
shows top side and bottom side of the same board.
Send me an e-mail to

On Apr 6, 12:01*pm, YK wrote:
I have a diode / filter cap power supply board for sale. Sold over
1000 since introduction 5 years ago. Now third generation board, clean
single board design. Uses top quality components, electrolytic cap is
2.2 times more than the original and the diodes are rated 3A 6000V PIV
in each leg. Bleeder resistors are 75K ohm / 6W each across caps.
Reduce heat substantially. No drilling or mod to the 30L-1 structure
for mounting. Sold for up to $99 by dealer. This is direct sale for
big savings. $59 each plus USPS shipping charge. 105 degree C high
temp upgrade version is $10 extra, free bias diode and electrolytic
caps included. Money back guarantee. Send *e-mail for photos.
The board is one board design, completed and tested *but the photo
shows top side and bottom side of the same board.
Send me an e-mail to

The correct e-mail is