Home |
Search |
Today's Posts |
#1
![]() |
|||
|
|||
![]()
FS is a Palomar Engineers VLF Converter. These converters are used to allow
reception of low frequencies from 10 to 500KHzs on receivers and transceivers that don't go that low. It is operated off of a 9 volt transistor battery and is easy to use. Below are the directions for use: Connect an antenna to the "10-500 KHz Antenna" connector. Connect a shielded cable from the "3.5-4 MHz Out" connector to a receiver that tunes 3500-4000 KHz. Clip a 9-volt transistor battery to the leads and slip it into the holder on the converter. Turn the switch to "ON". Tune the receiver to 3500 KHZ where a strong carrier should be heard - this is the converter local oscillator. Tune the receiver up from 3500 kHZ. The VLF signals heard will be at the dial reading less 3500 KHZ. This converter is used and in very good condition. Price is $45 plus shipping. Thanks, Charlie Hugg, K5MBX ___________________________ See my Signal/One, Collins & Drake Photo Galleries and my Hallicrafters Virtual Museum at http://hug-a-bug.com |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
FS Palomar VLF Converter | Boatanchors | |||
How to fix distorted sideband audio on a Palomar 300 Elite | CB | |||
FA: Palomar VLF Converter | Swap | |||
WARNING Passport on Liypn's AC converter | Shortwave | |||
Palomar 300A Amp Help... | CB |